Our Rugged Portable Field Research Computer System

Return To Player Page

Warning! The following diagrams are provided for reference only.

We accept no responsibilty for damages that may occur as a result of somehone attmepting to build this circuit.
If you opt to build this circuit, check it with load resistors before powering anything you actually care about. Even the best technicians make mistakes. The +5 Volt supply should be checked with a 1 ohm load resistor, and should not drop more then a few hundeed millivolts. The 12 Volt supply should be tested with a 10 Ohm load resistor and should not drop more then a few hundred millivolts. There should not be more than a hunderd millivolts of ripple on either supply under a load.
Continue to Power Supply Page
Return to player Page